Series V69 | Hi-Build Epoxoline II

Generic Type Polyamidoamine Epoxy
Common Usage An advanced generation epoxy for protection and finishing of steel and concrete. It has excellent resistance to abrasion and is suitable for immersion as well as chemical contact exposure. Contact your local Tnemec representative for a list of chemicals. This product can also be used for lining storage tanks that contain demineralized, deionized or distilled water. Note: Series V69 conforms with air pollution regulations limiting Volatile Organic Compounds (VOC) to a maximum of 250 grams/litre (2.08 lbs/gal) in areas requiring less than 100 grams/litre VOC, please refer to the Series L69 data sheet.

The products listed below are not exact equivalents. They are only products that you may consider as alternatives in a general sense. Substrate type, condition, temperatures, surface preparation, primer/topcoat selection and intended use are just a few factors that will affect product selection. Please contact your local Tnemec Coatings Consultant for product recommendations.

This ProductPolyamidoamine Epoxy
Volume SolidsRec. DFTV.O.C.# of Components
    
Series N69 | Hi-Build Epoxoline II Polyamidoamine Epoxy
Hide this product's data
Volume SolidsRec. DFTV.O.C.# of Components
67.0 ± 2.0% (mixed) †2.0 to 10.0 mils (50 to 255 microns) per coat. Note: MIL-PRF-4556F applications require two coats at 4.0-6.0 mils (100-150 microns) per coat. Otherwise, the number of coats and thickness requirements will vary with substrate, application method and exposure. Contact your Tnemec representative.N69 - Unthinned: 2.40 lbs/gallon (285 grams/litre) V69 - Unthinned: 1.95 lbs/gallon (234 grams/litre)
Thinned 10% (No. 4 Thinner): 2.80 lbs/gallon (334 grams/litre) Thinned 2.5%: 2.08 lbs/gallon (250 grams/litre) †
Thinned 10% (No. 60 Thinner): 2.80 lbs/gallon (335 grams/litre)
Two: Part A (amine) and Part B (epoxy) — One (Part A) to one (Part B) by volume.
Series N69F | Hi-Build Epoxoline II Polyamidoamine Epoxy
Hide this product's data
Volume SolidsRec. DFTV.O.C.# of Components
69.0 ± 2.0% (mixed) †2.0 to 10.0 mils (50 to 255 microns) per coat. Note: The number of coats and thickness requirements will vary with substrate, application method and exposure. Contact your Tnemec representative.N69F
Unthinned: 2.30 lbs/gallon (280 grams/litre)
Thinned 10% (No. 4 Thinner): 2.75 lbs/gallon (330 grams/litre)
Thinned 10% (No. 60 Thinner): 2.76 lbs/gallon (331 grams/litre)

V69F
Unthinned: 1.90 lbs/gallon (228 grams/litre)
Thinned 3.5% (No. 4 Thinner): 2.08 lbs/gallon (250 grams/litre) †		Two: Part A (amine) and Part B (epoxy) — One (Part A) to one (Part B) by volume.

Email this product

Support Documents