||Modified Polyamine Epoxy
||High-solids moisture tolerant epoxy used for priming concrete, wood and drywall. Also as a stand-alone one-coat clear floor sealer.
||Clear. Can be field-tinted (Series 820 Field Tint) in 16 StrataShield colors and certain custom colors. Note: Epoxies chalk with extended exposure to sunlight. Lack of ventilation, incomplete mixing, miscatalyzation or the use of heaters that emit carbon dioxide and carbon monoxide during application and initial stages of curing may cause yellowing to occur.
||Series 130, 215, 217, 218, 1254
Note: A repair kit of 201, with Part C fumed silica, is available for small patching/surfacing repairs. For more extensive repairs and additional information, contact your Tnemec representative or Tnemec Technical Services.
||Series 201, 206, 206SC, 210, 222, 223, 224, 237, 237SC, 238, 239, 239SC, 270, 273, 280, 281, 282, 406, 434, 435, 436.
Note: Refer to the applicable topcoat data sheet for color availability and additional information.
||Concrete: Horizontal: 6.0 to 12.0 mils (150 to 305 microns) per coat. Vertical - 4.0 to 6.0 mils (100 to 150 microns) per coat.
Wall board, Drywall & Wood: 4.0 to 6.0 mils (100 to 150 microns) per coat—two coats applied at 30 to 45 minute intervals.
Curing time varies with surface temperature, air movement, humidity and film thickness.
|Temperature || Maximum Recoat Time || To Place in Service|
| 75°F (24°C) || 24 hours || 24 hours |
Ventilation: When spray-applied, provide adequate ventilation during application and cure. Reference ventilation guidelines contained in the latest edition of AWWA D 102. Note: If Series 201 is used as the primer for a mortar system, the mortar application should take place while the Series 201 is still tacky, typically up to four hours, otherwise, aggregate should be lightly broadcast into the primer so to provide tooth to hold the mortar in place when spread. When the Series 201 is used as a vertical or horizontal primer for a thin film system, the 201 should be allowed to dry hard without exceeding the 24 hour recoat window. If Series 201 is used as the primer for the Series 270 Stranlok system, the Series 201 should be allowed to tack up for approximately one to four hours depending upon temperature but not allowed to dry hard.
|Volatile Organic Compounds
||Unthinned: 0.24 lbs/gallon (28 grams/litre)
Thinned 5% (No. 2 Thinner): 0.57 lbs/gallon (68 grams/litre)
Thinned 5% (No. 42 Thinner): 0.55 lbs/gallon (65 grams/litre)
||Unthinned: 0.0 lbs/gal solids
Thinned 5% (No. 2 Thinner): 0.37 lbs/gal solids
Thinned 5% (No. 42 Thinner): 0.0 lbs/gal solids
||1,604 mil sq ft/gal (39.4 m²/L at 25 micons). See APPLICATION for coverage rates.
|Number of Components
||Two: Part A and Part B (2 Parts A to 1 Part B by volume)